Put your fence on a regular maintenance schedule and check the support structure first, repairing or replacing any damaged posts and rails. Grab each post at the top and put pressure on it from all sides. If it’s properly seated in the ground, it should move little or not at all. Movement may signify rot at the base and the need for replacement. Do the same for the rails, and repair them if necessary. Look for mildew, especially on the lower sections of the fence, and clean it with a 1-to-3 bleach-water solution, letting the section soak for 20 minutes and keeping it wet during this period. Then scrub the area with a stiff brush, rinse it with a garden hose, and let it dry thoroughly before painting. If your fence is in good repair, it may benefit from a yearly power washing to remove dirt. Use a fan head and low pressure to avoid gouging the wood. In time, all unfinished woods will turn gray when exposed to the weather. Common naturally resistant species used in outdoor construction, such as redwood and cedar, weather without deteriorating. These woods can be further protected with weather-resistant finishes, and you can induce a weathered appearance with bleaching oils, a mixture of linseed oil and bleach crystals—if you don’t want to wait for nature to do the work.

What You Need

Wide putty knifeNail setCordless drillPaintbrushesSandpaperExterior wood fillerStain-blocking primerHigh-quality acrylic exterior paint

How to Paint a New Wood Fence

Step 1: Prep Fence

On a new fence or gate, set nails and screws below the surface, fill all cracks and nail holes with an exterior-grade wood filler, and spot-seal knot holes with an exterior sealer. This will keep the knots from bleeding through the finish paint.

Step 2: Prime and Paint

Using roller, sprayer, or a brush sized appropriately to the fencing, apply stain-blocking primer to the wood. If you use a roller or spray gun, follow the application by back brushing, working the primer into the spaces between the fence boards. Paint with a high-quality exterior acrylic paint.

Tip: Paint Before Assembly

If you’re constructing a new fence or gate, prime and finish the individual parts of the structure before you assemble them. That way, you are assured of getting more complete paint coverage and better protection. Painting before assembly will reduce your maintenance chores in the long run.

How to Spray Paint a Fence

Spraying a wood fence requires the same preparation as brushing it but gets the paint on quickly. Protect vegetation and porch and deck surfaces from overspray. Back-brush the surface.

If you don’t like the factory-galvanized gray of your chain-link fence, transform it with a coat of paint. On new chain link, etch the surface with household vinegar, then paint. On weathered fences, just roll the paint on both sides with a long-nap roller.

How to Paint with a Mitt

A paint mitt can make quick work out of painting narrow boards or square or round balusters. Put the mitt on your painting hand, dip it into the paint bucket, and squeeze out some of the excess. Then grab the board with the mitt and slide down it.

How to Refinish an Old Gate

To rejuvenate an old gate, first make structural repairs as necessary, replacing rotted boards and squaring the gate by shoring up the frame. Scrape off any loose paint with a scraper or remove it with a heat gun and wide putty knife. Set nailheads and drive screws slightly below the surface of the wood. Fill holes with an exterior wood filler, sand, prime with a stain-blocking primer, and paint with a high-quality acrylic exterior paint.